Marshall Electronics V-R653-IMD-TE Operations Instructions download pdf (Page 17)

• Pixel to Pixel Enable/disable Pixel-to-Pixel mode

• Ctemp/Gamma Rotate amongst color temperature settings

• Blue Only Enable/disable Blue Only mode

• Monochrome Enable/disable Monochrome mode

■ Save Defaults

Use this setting to save the current values of the Color, Brightness, and Contrast controls as the default values. The defaults can

then be accessed by pushing the knob twice.

• Back Exit without making any changes

• Save Save current settings as defaults

• Mfg Return to the manufacturer’s defaults (all settings at 50).

■ Saving and Loading User Presets

Use the SAVE CONFIG and LOAD CONFIG menus to save current settings to one of 6 presets, or load a preset. Each Preset saves

all monitor settings except for IMD configuration.

• Use the LOAD CONFIG menu to load one of presets USR1 – USR6. Factory default settings can also be loaded by

selecting MFG. (Factory defaults cannot be overwritten.)

• Use the SAVE CONFIG menu to save the current settings to a preset from USR1- USR6.

■ Green, Red, Yellow GPI

Use the GPI settings to determine the function of a specific Tally pin on the back of the unit. The GPI Pin actions are toggled by

bringing the pin LOW. The Red, Green or Yellow Tally pins can activate a variety of settings, listed below.

• Tally Illuminate Green, Red or Yellow Tally LED

• Monochrome Enable/disable Monochrome mode

• Blue Only Enable/disable Blue Only mode

• Pixel to Pixel Enable/disable Pixel to Pixel mode

• Audio Monitor Display/hide Audio Presence indicator

• OSD Tally Rotate amongst types of OSD Tally

• IMD Display/hide IMD text

• CTemp/Gamma Rotate amongst CTemp/Gamma presets

• Aspect Ratio Toggle between 4:3 and 16:9 aspect ratios

• Anc. Time Code Display/hide time code

• Marker Level Rotate amongst marker settings

The following settings are activated only when the Green, Red or Yellow Pin is brought into a LOW state by connecting it with

one of the GND pins. Once the Tally Pin is brought HIGH again (remove the connection to GND), the settings will be deactivated.

• Monochrome (L) Rotate amongst color temperature settings

• Markers (L) Enable/disable Blue Only mode

• Marker Mask 50% (L) Enable/disable Monochrome mode

• Marker Mask Black (L) Enable/disable Blue Only mode

• Marker Center(L) Enable/disable Monochrome mode

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

No comments

Marshall Electronics V-R653-IMD-TE Operations Instructions Page 17